Brouwer Kesmac 4000 R Series, Руководство оператора

Страница: 40 / 161

OPERATION
Roll-Up Conveyor
The Roll–Up Conveyor ‘ A ’ continues the Roll–Up action after
the Roll has passed through the Starter Trays ‘ B ’.
Adjust the Hanger Chain ‘ C ’ to allow 2 to 2 ½ inches
clearance between the bottom of the Roll-Up Frame ‘ D ’
and the upper Starter Tray ‘ B ’.
Index Conveyor
The Index Conveyor ‘ E ’ is synchronized to the Main
Conveyor, Robotic Arm and Bad Roll ‘Ejection’ Cylinder ‘ H ’.
When a Roll is ready to be transferred to the Index Conv-
eyor, the Index Conveyor automatically rolls back ‘one
position’, to accept the completed roll.
Bad Roll Ejection.
To ‘ eject ’ a bad roll of sod, the Roll Eject mat starts and the
Idler End Assembly ‘ F ’ is pulled back on Guide Rods ‘ G ’ by
Cylinder ‘ H ’, allowing the reject roll to drop onto the ground.
To activate the Roll Ejection refer to the Controls Section,
page 2-02.
WARNING
Do not attempt to clear jammed rolls or debris while the
machine is running. Keep all bystanders well
clear of the Index Conveyor, Gripper Head and Pallet
Injection area. Failure to do so could result in serious
injury or death.
Roll Position Sprockets.
IMPORTANT
The Roll Position Sprockets are adjusted with the Lift Arms
Adjuster to ‘just’ hold the Roll. They must not ‘compress’ it.
The Roll Position Sprockets hold the sod roll as it is trans-
ferred to the Index Conveyor.
The sprockets automatically lift when a bad roll is ejected.
CAUTION
To prevent possible personal injury:
If the Roll Position Arms are raised manually, to clear debris
or jammed rolls from the Index conveyor, ensure that the
Locking Pin ’
K ’ is pushed in and fully engaged against the
Lift Arm ‘ L ’.
Roll Flap Position.
The position of the Roll Flap is set using the control buttons
on the Control Handle, (see page 2-02).
The sensing ‘teeth’ are on a Sprocket located at the right
rear of the Main Conveyor. (See page 5-08).
The Proximity Sensor senses and counts the teeth.
Increasing the ‘tooth count’ moves the Roll Flap ‘
counter-
clockwise’ .
Decreasing ‘tooth count’ moves the Roll Flap ‘ clock-wise ’.
Adjust the location of the Roll Position Sprockets to suit the
selected position of the Roll Flap.
3-02