Brouwer Kesmac 4000 R Series, Руководство оператора

Страница: 116 / 161

MAINTENANCE
Conveyor Mat Sliders.
Service life of Conveyor Sliders varies depending on the
soil conditions.
Inspect them for excessive wear, particularly under the
Roll-up Tray, when replacing the Mat and at major service.
The Sliders ‘
A, ’ fit onto ‘T-Section’ Rails and are fastened at
the lower end with Flat Head S.S. Screws ‘ B ’ and Locknuts.
Excessive wear will be evident when the frame rails show
through the Sliders.
Wear thickness,
3/8 inch , is less than the overall thickness.
Remove/Replace Upper Slides.
•
Locate a join in the Mat and position it at the mid-
point of the Conveyor Frame.
•
Remove the Idler Tension Springs,see page 6-02.
•
Remove the Mat Splices and Rubber Joiner ‘ C ’.
See page 6-03 reference replacement kit.
•
Pull the Mat clear of the top Drive Sprockets and
off the bottom front Crown Roller.
•
Remove the Screws and Locknuts fastening the
Sliders to the frame rails, and pull the Sliders up
and off the Rails. It may be easier and quicker to
cut badly worn Sliders off the Rails. Clean up the
rails for easier fitting of the new sliders.
•
Feed the Slider onto the rail, from the top. ‘Knock’
it down the rail until the bottom fasteners can be
fitted.
Always replace the Sliders as a set.
Lower Sliders.
To replace the Lower Mat Sliders ‘D’ :
•
Remove the Locknuts ‘E’, and lift the Sliders
off the rails
•
Remove ‘T-Bolts’ ‘ F ’, from the Sliders and fit them
into the new Sliders, and bolt them into place.
Roll-up Conveyor Bump Stops.
The Roll-up Conveyor is a Mintex Metal Mat.
See page 6-07 for details on the Mintex Mats.
•
Roll-up Conveyor Bump Stops ‘ G ’, are attached on
both sides of the Frame.
•
Replace badly worn or damaged Bump Stops.
6-06