Brother RH-981A, Руководство по обслуживанию

Страница: 125 / 138

7. SOFTWARE
RH-981A
117
Check code Function
C-01
After activating the buzzer for a second, X-, Y-, and θ -home positions are detected when the
machine stops with the needle at its upper limit.
(Head sensor will not conduct any error check.)
C-02 The machine will hold the material.
C-03 The machine will open the material.
C-04
After activating the buzzer for a second, the machine opens the material, turns 180 ˚ ( θ ), and
activates lower thread and lower gimp trimmers.
C-05
After activating the buzzer for a second, turns 180 ˚ ( θ ), and the upper thread trimmer will be
activated.
C-06
After activating the buzzer for a second, the machine will hold the material and activate the
hammer.
C-07
After activating the buzzer for a second, the machine will hold the material, and operate the
machine motor at 700rpm.
Turn off the start switch to stop the machine.
C-10 Upper thread will be tightened.
C-11
After activating the buzzer for a second, the X feed mechanism will reciprocate in the range of
–6 mm to + 6 mm.
Note:
Be sure to remove the work clamp and check the motion of the X feed mechanism.
C-12
After activating the buzzer for a second, the Y feed mechanism will reciprocate in the range of
–1 mm to + 65 mm.
Note:
Be sure to remove the work clamp and check the motion of the Y feed mechanism.
C-13
After activating the buzzer for a second, the θ feed mechanism will reciprocate in the range of
–2.7 ˚ + 362.7 ˚ .
Note:
Be sure to remove the work clamp and check the motion of the θ -axis feed mechanism.
C-16 *1 Feed plate is temporarily fixed. (Fixing cylinder on)
C-17 *1 Feed plate is fixed. (Chuck cylinder on)
C-18 *1 Feed plate is moved to the right. (Cloth feed driving cylinder on)
C-19 *2
After the feed bracket moves forward, the hammer plate of the hammer selector assembly
drops.
Note:
Be sure to remove the work clamp and check the motion of the hammer plate.
C-20 *3 Upper thread nipper [1] (up/down) turns on.
C-21 *3 Upper thread nipper [2] (open/close) turns on.
C-31 The buzzer sounds.
C-32 All indicators on the operation panel will be lit.
*1 Available only when indexer is attached.
*2 Available only when special lapel cutting device (optional) is attached.
*3 Available only when upper thread nipper (optional) is attached.