Brother GTX600NB, Инструкция по эксплуатации

Страница: 34 / 332

1-20
Before Using Your Printer for the First Time
Supply from a tank
<IMPORTANT>

Fill the tank with pure water.

Use a clean container to supply water to the tank.

Install the tank about 31.5 in. (80 cm) above the installation location of the printer.
If the height is insufficient, water may not be supplied to the printer.

The tube should be laid on the floor, and the length should be 49.2 ft. (15 m) or less. Piping should be done so that the height
difference between the tubes is about 5.9 in. (15 cm).

Limit the number of L-shaped fittings to three per flow path.

Be sure to mount a cable cover with sufficient strength to the tube.
Water will not be supplied and may leak to the floor if the tube is broken or cut off.

Lay the tube so that the bending radius is 2.0 in. (5 cm) or more.
If the bending radius is small, the tube may break.

If the tube is broken during laying, do not use the broken part.

Do not use the optional humidifier water supply tube to connect to tap water piping.

Loosen the tank's cap during use.

Verify that the faucet is in the closed position before inserting or removing the tube. Failure to do so could allow the water to flow
out of the tank.

Check inside the water supply tank once a month. Clean inside the tank if you notice any bad odor or discoloration.
Printer Tank