Bridgeworks WANrockIT 200, Руководство пользователя

Страница: 12 / 83

Installing the WANrockIT 200 Node
The following are the basic steps to installing the WANrockIT 200:
• Connecting the Ethernet cables
• Connecting the Fibre Channel Interface
• Connecting the Power Supply
Connecting the Ethernet Interface
The WANrockIT 200 Management Interface and onboard WAN Interface can be used on the
following network configurations:
• 10BASE-T
• 100BASE-T
• 1000BASE-T (Gigabit)
It is not necessary to specify which network type you are connected to, as the WANrockIT 200 will
automatically select the correct network speed.
The connection to the management Ethernet network can be found at the back of the WANrockIT
200, labelled “MGMT A”.
To connect the WANrockIT 200 to the management Ethernet network, insert a Cat 5E cable (or
better) into the “MGMT” port at the back of the unit . When the plug is in the correct position a “click”
should be heard. The other end of the cable should be connected to a network.
The WAN port can be found at the back of the WANrockIT 200, labelled “WAN”.
To connect the “WAN” port, insert a Cat 5E cable (or better) in to the port. The other end of the
cable should be connected to a network.
Important: If the “WAN” port is connected to a congested network, the
performance of Node-to-Node data transfer may be affected.
Connecting the Fibre Channel Interface
With a 8Gb Fibre Channel card installed, the WANrockIT 200 may utilise the following link speeds:
• 2GB
• 4GB
• 8GB
12