Bravi Platforms Sprint LUI MINI P.A., Руководство пользователя

Страница: 6 / 39

1.7 CRUSHING AND IMPACT HAZARDS
•
All personnel, whether operational or on the ground, must wear the
personal safety equipment required by the regulations in force or by
the risk analysis performed in the workplace.
•
When the machine is being used or the platform is being raised or
lowered, make sure to observe the distances above, below and on
both sides of the platform itself.
•
When the machine is in operation, do not lean out from the platform
railings.
•
When driving the machine in areas of limited visibility, have an as-
signed person proceed ahead so as to indicate any eventual hazard.
•
When driving, always keep non operational personnel at a distance of
at least 1.8 metres (6 feet) from the machine.
•
Adjust the driving speed based upon the following conditions: ground
or floor surface conditions, traffic, visibility, slope, location of other
personnel and any other factors that could constitute a hazard of colli-
sion or personal injuries.
•
Keep the braking distances in mind independently of the speed of the
machine.
•
Do not drive at high speed in restricted, tight or narrow areas or in
reverse gear.
•
Always pay maximum attention so as to avoid that eventual obstacles
collide with the operational commands or the person on the platform
or that they interfere with the same.
•
Make sure that the operators of other machines that are elevated or
on ground level are informed regarding the presence of the aerial
platform. Disconnect the electrical power to elevated cranes.
•
Advise other personnel not to work, stand, or transit under the elevat-
ed platform. Delineate the floor or ground with appropriate barriers,
as needed.
SECTION 1.
SAFETY PRECAUTIONS
1.8 LIFTING AND TRANSPORT
General information
•
During lifting and transport, personnel are prohibited from standing
on the platform.
•
Push or tow, for LUI PKI, the machine exclusively in the event of an
emergency, malfunction, power interruption or to load or unload it
and ALWAYS after having unlocked the motor - brake, according to
the instructions found in this manual.
•
Before lifting or transport, make sure that the platform has been
completely lowered and is empty.
•
During lifting of the machine by way of a fork lift, arrange the forks
exclusively in correspondence to the appropriate areas of the ma-
chine itself. Carry out the lift by way of a fork lift with an adequate
load capacity. For the weights of the machine consult the technical
specifications table in Section 5 - Technical Specifications of the
Machine.
•
For lifting information, consult, section 3 - Machine Operation, in this
manual
.
10 11