Lenox® Lockers (includes Cubby & “Z” Lockers)
Installation
12
10/24/07
Bradley Corporation • LK-INSTR-001 Rev. K; EN 07-1303
Figure 8
Installation Instructions continued . . .
Step 8: End Panel Installation (optional)
NOTE: Optional slope top not shown in Figure 8.
NOTE: The end panels can be cut to size with a panel saw if necessary. Only the front edge has a
radius and should not be cut.
1. Drill five 3/16" dia. holes through each of the exposed locker side(s) where the end panel is to be
attached at the locations shown in Figure 8. Do not drill holes into the end panel.
2. Fasten the end panel to the locker(s) using the #6 x 5/8" screws provided (see Figure 8). The
screws must be inserted through the inside of the locker and screwed into the end panel. The
screws will not protrude through the end panel.
#6 x 5/8" SCREW
(FAST-LF006)
