Lenox® Lockers (includes Cubby & “Z” Lockers)
Installation
8
10/24/07
Bradley Corporation • LK-INSTR-001 Rev. K; EN 07-1303
Installation Instructions continued . . .
Step 5: Optional End Filler Installation
NOTE: Fillers are designed to fill gaps between locker
runs. They are cut to size by the installer and attached
with 3-4 suitable fasteners supplied by the installer. The
fillers are attached to either an adjoining locker or
blocking (the blocking provides support at the end of a
locker run). If fillers are being attached to a wall,
attach the blocking to the wall first, then secure with
suitable fasteners (blocking and fasteners are supplied
by installer). Make sure the blocking is positioned so
that the filler will be flush with the face with the locker.
NOTE: Be sure to attach the filler to the proper side of
the locker per your submittal layout.
1. Cut the end locker filler to size.
2. Align the filler to the locker top and front and
temporarily clamp in place.
3. Using the holes in the filler as a template, drill
four 9/32" dia. holes through the locker (refer to
Figure 2 on page 5).
4. Secure one side of the filler to the locker with the
#10-24 male and #10-24 x 1/2" female sex bolts
provided.
5. Secure the other side of the filler to the blocking
(fasteners provided by installer).
Step 6: Number Plate Installation
NOTE: Installation of the number plate is for a
standard or “Z” locker only. Cubby locker does
not have a number plate.
1. Determine the locker number sequence.
2. Position the number plate in the recess in the
locker door (see Figure 6).
3. Hold the plate in place with your finger and,
using a pop rivet gun, install the two rivets
into the plate from the front of the locker.
Figure 6
Figure 5
END
FILLER
BLOCKING
(provided
by Installer)
RIVET
(FAST-LF029)
