Lenox® Lockers (includes Cubby & “Z” Lockers)
Installation
10
10/24/07
Bradley Corporation • LK-INSTR-001 Rev. K; EN 07-1303
Installation Instructions continued . . .
Step 7a: Slope Top (cont’d.)
3. If a corner slope top is being installed, position that slope top first. Fit the groove of the slope top
over the front edge of the locker while at the same time pressing down on the score line of the
slope top as shown in Figure 7c. Rest the back edge of the corner slope top onto the wall strip.
4. Fit the groove of the next slope top section over the front edge of the locker as shown in Figure
7c. Rest the back edge of the slope top section onto the wall strip.
5. Secure the slope top to the locker with the #8 x 1-1/4" Lg. screws provided (see Figure 7c). Do
not overtighten screws.
NOTE: If desired, caulk the gap in the back edge of the slope top where it meets the wall strip.
6. Measure, modify and install the remaining slope tops for a custom fit.
WALL
STRIP
1-1/4"
Figure 7c
NOTE:
The Corner Slope Top is
shipped flat with a score at
the bend. To form the bend,
press down at the score line
during installation. DO NOT
OVERBEND.
score line
CORNER
SLOPE TOP
Press down along this
line to form the bend
during installation.
CORNER
SLOPE TOP
Install slope top with
groove side facing down
SLOPE TOP
SECTION
#8 x 1-1/4"
SCREW
(FAST-LF041)
1/4" x 2-1/4"
TAPCON SCREW
(FAST-LF042)
