- 59 -
The settings for speed and pulling direction are made in the „gear“ tab.
„stroke“
The direction of the stroke is parametrised here. The default is „Pulling
direction“. The „Starting position“ setting is only required for special appli
-
cations. If you have any questions, please contact your Bossard partner.
„start-up ramp“
This time defines the ramp with which the motor moves to the target
speed, recommended value 0.1 - 0.2 seconds.
„control method“
Adjustment of the engine control. „Setting speed“ is the default setting.
In the „Control speed“ control mode, the tool keeps the speed constant
even under load.
„regulate rpm“
The rpm control corresponds to a closed control loop. The tool will try to
maintain the set speed even under load.
„set rpm“
The rpm control corresponds to an open control loop. The tool will not
readjust the speed under load.
„rpm + force“
The rpm control is dependent on the measured force. Only possible
when F
Target
(NBPF-25) is activated
„setting speed
Target
“
Adjustment of the setting speed in %. Recommended setting for screw
-
ing-on, level 1, 50%, for setting, level 2, 80 - 100%.
„setting speed
min
“
Adjustment of the minimum setting speed
Содержание RTB-20
