- 64 -
4.4.17 Program → Option
The options for the program can be configured under Program Option.
„F
min
“
F
min
describes the minimum force for this step. If a force below this value
is reached, no rivet has been set. The tool shows „Blank stroke“ or „Leer
-
hub“ on the display, depending on the language setting
„pressure trigger“
The tool has a monitoring system that automatically detects the break
-
age of the rivet mandrel and causes the tool to move back to the starting
position. Depending on the pulling head or fastener, breakage detection
must be deactivated. Breakage detection is only active if the checkbox
is enabled.
„QuickRiv-Technology“
The pressure control ensures that the blind rivet can only be processed
when the pressure control is activated. This prevents accidental trigger
-
ing and ensures that the components to be processed are in contact
with each other.
Pressure control is only active if the checkbox is enabled.
„confirm OK“
If this checkbox is selected, an OK setting must be acknowledged
„record graph F
start
“
If this checkbox is selected, graphic recording starts from the entered
force value.
„1×NOK → cancel job“
If this checkbox is selected, the program is aborted in the event of an
NOK.
Anzeige mit Spracheinstellung
Deutsch
Anzeige mit Spracheinstellung
Englisch (default)
Содержание RTB-20
