18
en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts
AutoDome Pendant Arm Mount
2. Drop the dome housing down slightly to engage the dome housing hook on the Pendant
Arm hinge pin, allowing the dome to rotate around the pin.
3. Rotate the dome housing down to a vertical position and gently push upward to engage
the connector on top of the dome housing.
CAUTION!
If you feel any resistance when rotating the dome housing or when engaging the connector,
stop immediately and start over.
4.
Hold the Pendant housing in position while tightening the two (2) 5-mm Allen head
mounting screws on top of the housing to
10-12 N-m (90-105 in.-lbs)
.
CAUTION!
You must tighten the two mounting screws to a minimum torque of 10-12 N-m (90-105 in.-lbs)
to ensure a proper seal between the arm and the housing.
F.01U.250.238 | 1.0 | 2011.08
Installation Guide
Bosch Security Systems, Inc.
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
Содержание VGA-PEND-ARM
Страница 2: ...Available from A1 Security Cameras www a1securitycameras com email sales a1securitycameras com ...
Страница 33: ...Available from A1 Security Cameras www a1securitycameras com email sales a1securitycameras com ...
Страница 34: ...Available from A1 Security Cameras www a1securitycameras com email sales a1securitycameras com ...
Страница 35: ...Available from A1 Security Cameras www a1securitycameras com email sales a1securitycameras com ...
