2.6
AutoDome Pendant Arm Mount
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
17
Attach Pendant to Arm and Tighten
NOTICE!
Before attaching the AutoDome Pendant, visually inspect the dome and arm connectors for
any blocked pin holes or bent pins. Refer to the
VG5 Series AutoDome Installation Manual
before connecting the pendant to the arm.
1.
Tilt the bottom of the dome toward the pendant arm base and place the mounting hook,
located on top of the dome housing, over the recessed hinge pin of the arm.
a
b
Figure 2.5
Attach Pendant to Arm
1
Tilt up.
2
Hook and drop.
2a Recessed Hinge Pin
2b Dome Connector
3
Rotate down to engage dome connector.
4
Tighten the two (2) mounting screws to a minimum torque of 10-12 N-m
(90-105 in.-lbs).
Bosch Security Systems, Inc.
Installation Guide
F.01U.250.238 | 1.0 | 2011.08
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
Содержание VGA-PEND-ARM
Страница 2: ...Available from A1 Security Cameras www a1securitycameras com email sales a1securitycameras com ...
Страница 33: ...Available from A1 Security Cameras www a1securitycameras com email sales a1securitycameras com ...
Страница 34: ...Available from A1 Security Cameras www a1securitycameras com email sales a1securitycameras com ...
Страница 35: ...Available from A1 Security Cameras www a1securitycameras com email sales a1securitycameras com ...
