Bosch VG5 600 Series, Руководство по установке

Страница: 73 / 88

AutoDome 600 Series Analog PTZ Camera Cable and Wire Standards | en 73
Bosch Security Systems, Inc. Installation Manual F.01U.265.793 | 2.0 | 2012.02
The following figure illustrates the connections for RS485 connections.
Figure 5.6 Connections for RS485 Operations
Figure 5.7 Position of CPU Switch for RS485 Operation (camera module not shown for clarity)
Note: To access the CPU switch you must remove the bubble from the pendant housing. Refer
to the procedure on Page 80 .
5.5 Fiber Optic Module with an RS232/RS422 Controller
An AutoDome with a fiber optic module is prewired to operate with Biphase signals only. This
section describes the procedures necessary to control a VG5 series AutoDome fitted with a
fiber optic kit using an RS232 controller or a Pelco® RS422 controller.
To control a VG5 Series Autodome from an RS232 or from a Pelco RS422 controller you must
run control wires from the controller to an LTC 4629 head-end fiber optic module.
1 C- (Biphase) 7 AutoDome Data In/Out
2 C+ (Biphase) 8 P105/P106 Connector
3 Earth Ground 9 Head End RS485
4 RxD 10 Data +
5 TxD 11 Data -
6 Signal Ground 12 Ground
1 Switch Location
2 LEDs
3 RS485
4 CPU Module
100 Ω