Bosch VG5 600 Series, Руководство по установке

Страница: 49 / 88

AutoDome 600 Series Analog PTZ Camera Installing the Roof Parapet and Pipe Mounts | en 49
Bosch Security Systems, Inc. Installation Manual F.01U.265.793 | 2.0 | 2012.02
3.6 Installing the VG4-A-9543 Pipe Mount
This section details the installation steps for the VG4-A-9543 Pipe Mount. If you are installing
the Roof Parapet mount, refer to Section 3.5 Installing the VG4-A-9230 Roof Parapet Mount , for
instructions.
Figure 3.9 Pipe Mount
1. Before installing the Top-Mounting Flange, ensure there is an adequate opening in the
ceiling or mounting structure for the wires to pass through.
2. Secure the pipe Flange with supplied gasket to the ceiling or other supporting structure
using four (4) 10-mm (3/8-inch) diameter fasteners.
3. Attach pipe (not supplied) to the Top-mounting Flange.
4. Route the power, video, control, and alarm wires through the Top-Mounting Flange and
down the pipe.
5. Wrap at least five layers of Teflon tape around the threads.
6. Apply the supplied thread sealant to the threads on the Pipe.
– Make sure all surfaces are clean and dry.
– Apply a bead of sealant completely around the leading threads of the male fitting.
– Force the adhesive into the threads to thoroughly fill all voids.
7. Thread the Pipe Cap onto the down pipe and tighten securely to prevent leaks. Refer to
Figure 3.9, Page 49 .
NOTICE!
Customer must supply 1-1/2 inch (NPS) pipe threaded on both ends with a minimum length of
5 inches (12.7 cm).
1 Gasket
2 Flange
3 Cap
5 in.
12.7 cm
min.
NOTICE!
Each fastener must have a minimum pullout strength of 275 kg (600 lbs). The mounting
material must be able to withstand this pull-out force. For example, 19-mm (3/4-inch)
minimum for plywood.
WARNING!
You must thread the pipe onto the Top-mounting Flange until it is tight. Failure to do so can
result in damage, serious injury or death.
WARNING!
You must thread the Dome Cap onto the pipe until it is tight. Failure to do so can result in
damage or serious injury or death.