Bosch VG5 600 Series, Руководство по установке

Страница: 42 / 88

42 en | Installing the Roof Parapet and Pipe Mounts AutoDome 600 Series Analog PTZ Camera
F.01U.265.793 | 2.0 | 2012.02 Installation Manual Bosch Security Systems, Inc.
3.4.2 Wiring the Power Supply Box
1. Route the high voltage 115/230 VAC lines through the conduit fitting on the left side of
the box.
2. Cut and trim the high voltage 115/230 VAC power and ground wires with sufficient slack
to reach their connector terminal in the box, but not so long as to be pinched by or to
obstruct closing the Cover Door. Refer to Section 3.1.1 Parts List, page 36 , for connector
location.
3. Attach the supplied 3-pin Power Plug to the incoming high voltage power wires in the
box. Refer to connector P101 in Table 3.1, Page 45 .
4. If you are using UTP for video, route the UTP cable out to where the AutoDome will be
mounted. Refer to Section 5 Cable and Wire Standards, page 67 for fiber optic
specifications.
5. Route the low power 24 VAC wires from the right side of the Power Supply Box out to
where the AutoDome will be mounted. Attach the supplied 5-pin 24 VAC Dome plug to
the wire ends inside the box. Refer to connector P107 in Table 3.1, Page 45 .
NOTICE!
The Power Supply Box with transformer comes with a barrier that separates the high voltage
side on the left from the low voltage 24 VAC side on the right.
NOTICE!
All video, control, and alarm wires either pass through the Power Supply Box or by-pass it and
connect directly to the Pipe Interface Board.