AutoDome 600 Series Analog PTZ Camera
Installing the Roof Parapet and Pipe Mounts | en
37
Bosch Security Systems, Inc.
Installation Manual
F.01U.265.793 | 2.0 | 2012.02
3.2
Pre-installation Check List
1.
Determine the location and distance for the power supply box based on its voltage and
current consumption. Refer to
Section 5 Cable and Wire Standards, page 67
for wiring
information and distances.
2.
Use only UL listed liquid tight strain reliefs for conduits to the Power Supply Box to
ensure that water cannot enter the box. You must use water tight conduits and fittings to
meet NEMA 4 standards.
3.
Install all rough wiring including: power, control, video coax, alarms I/O, relay I/O, and
fiber optic cabling. Refer to
Section 5 Cable and Wire Standards, page 67
for video and
control protocol methods.
4.
If you plan to use the RS232 or RS485 protocol to control the AutoDome, refer to
Section 5.4.2 Controlling the AutoDome via the RS232 Protocol, page 71
, or
Section 5.4.3 Controlling the AutoDome via the RS485 Protocol, page 72
, for instructions on
configuring the AutoDome to accept these protocols.
5.
Choose the appropriate VG5 AutoDome model (indoor or outdoor) for the environment in
which it will be used.
6.
If this AutoDome installation utilizes the AutoTracker feature, refer to
Section A Installation Notes for AutoTracker, page 82
, before mounting the AutoDome.
7.
Purchase the appropriate mounting hardware to use, depending on the location of the
AutoDome and the application.
NOTICE!
Power and I/O cabling must be routed separately inside different permanently earthed metal
conduits.
WARNING!
External interconnecting cables are to be installed in accordance to NEC, ANSI/NFPA70 (for
US application) and Canadian Electrical Code, Part I, CSA C22.1 (for CAN application) and in
accordance to local country codes for all other countries.
Branch circuit protection incorporating a 20 A, 2-pole Listed Circuit Breaker or Branch Rated
Fuses are required as part of the building installation. A readily accessible 2-pole disconnect
device with a contact separation of at least 3 mm must be incorporated.
CAUTION!
Select a rigid mounting location to prevent excessive vibration to the AutoDome camera.
Содержание VG5 600 Series
Страница 1: ...AutoDome 600 Series Analog PTZ Camera VG5 600 Series en Installation Manual ...
Страница 2: ......
Страница 87: ......
