Bosch VG5 600 Series, Руководство по установке

Страница: 46 / 88

46 en | Installing the Roof Parapet and Pipe Mounts AutoDome 600 Series Analog PTZ Camera
F.01U.265.793 | 2.0 | 2012.02 Installation Manual Bosch Security Systems, Inc.
2. Prepare the mounting surface for the type of fastener by drilling holes for the mounting
anchors as required.
Figure 3.6 Parapet Wall Mount Bracket and Roof Mount Plate
3. Apply a weatherproof sealant around each fastener hole at the mounting surface.
4. Attach the Parapet Wall Bracket using at least six (6) stainless steel fasteners, three (3)
on each side (the bracket has eight (8) holes). Be careful not to over tighten the
fasteners because it may strip the threads. If attaching the parapet mount to a flat roof,
attach the optional LTC 9230/01 Roof Mount Plate to the roof and then attach the
Parapet Wall Bracket to the Roof Mount Plate.
1 Pipearm 4 Apply sealant around each fastener hole
2 Parapet Wall Bracket 5 Roof Mount Plate
3 3/8-16 SS Hex Head Bolt (supplied) 6 Use a minimum of six (6) fasteners (not
supplied). Eight (8) fastener holes shown.
NOTICE!
Fasteners are not supplied with the Roof Parapet Mount Kit since it depends on the material
to which it is attached. The material must accommodate a minimum pull out strength of 275
kg (600 lbs). For example, 19 mm (3/4 inch) minimum for plywood. Fasteners can include
bolts, studs, or lag bolts. All fasteners must be made of corrosion-resistant stainless steel,
with a diameter of 10 mm (3/8 inch).
All bolts must fully extend through the mounting surface and be secured with a flat washer,
lock washer and a nut. All studs must be anchored to concrete or welded to a steel backing
plate. Anchor bolts can be used for blind structures where there is no access to the rear.