Bosch Rexroth WS290, Руководство по эксплуатации

Страница: 64 / 104

64/104 Bosch Rexroth AG Hydraulics training system WS290 | RE 00225-B/2.15
Set-up, installation and commissioning
Fig. 38: Filling the hydraulic power unit
How the hydraulic power unit is filled:

Clean the environment of the filler inlet.

Loosen the filler and breather cap and lay them aside.

Push the filter funnel into the oil filler.

Fill in hydraulic oil up to the "MAX" marking visible in the oil-level glass
(see fig. 38).

Wait for about 15 minutes until the hydraulic fluid settled down in the tank.
This is also valid if you only refill partial quantities.

Close the tank filler with the filler and breather cap.

Remove any leaking hydraulic oil by means of the cleaning cloths.
Always dispose of contaminated cleaning cloths properly.
The oil tank is now filled.
Filling the hydraulic power unit
CAUTION
Risk of injury!
Slip hazard due to leaking hydraulic oil.

Immediately bind/dispose of leaking hydraulic fluid.

Provide binding material before the filling, re-filling or change of
hydraulic fluid.