D9068
|
Operation and Installation Guide | 5.0
Programming
.
Bosch Security Systems, Inc. | 3/13 | F01U071094-0
7
49
All programming, including the
point configurations and option
selections, is lost when this
operation is performed.
The Date/Time settings are not
affected when the D9068 uses
the default settings.
To set the D9068 to the original factory
programming configuration:
1.
At the Prog Defaults submenu, press
[2] to select
2: DEFAULT ALL EE
. The
window shows:
DEFAULT EE?
NO: YES (1)/NO (0)
2.
The entry preceding the colon (:) on
the second line indicates the current
setting. To restore the D9068 to its
factory settings, press [1] and
[# Command].
3.
Press [* Clear]. The window shows:
SETTING EEPROM
TO DEFAULT...
3: DEFLT 4/2 CDES
To access
DEFLT 4/2 CDES
, select
[0]: PROGRAM
[7]: PROG DEFLTS
[3]:
DEFLT 4/2 CDES
. This option sets all of
the programming for 4/2 codes to the
default.
To set all 4/2 code programming to the
default:
1.
At the Prog Defaults submenu, press
[3] to select
3: DEFLT 4/2 CDES
. The
window shows:
DEFLT 4/2 CDES?
NO: YES (1)/NO (0)
2.
The entry preceding the colon (:) on
the second line indicates the current
setting. To default 4/2 reports,
press [1] followed by [# Command].
Pressing [* Clear] shows:
SETTING EEPROM
TO DEFAULT...
5.4.8 SERIAL CONECTN
To access
SERIAL CONECTN
, select
[0]: PROGRAM
[8]: SERIAL CONECTN
. This
menu selection allows the D9068 to be
configured to use the serial connection
to a Bosch D10024/D10024A or D8024.
Analog FACP
: Setting this option to
Yes
enables the D9068 to communicate with a
D10024/D10024A or D8024 using an RS-232
serial link. If the serial connection is
set to
YES
and interrupted, such as
connecting a keypad, an Event Serial
Fail is generated. A Serial Restore is
generated when communication restores.
For more information, refer to
F: D8024/D10024/D10024A Analog FACP
Operation
and the
D9068 Quick
Start
(P/N: 48575).
To configure the D9068 to use the serial
connection to a D8024 or D10024/D10024A
Analog FACP:
1.
At the Programming Menu, press [8] to
select
8: SERIAL CONECTN
. The window
shows:
SERIAL CONECTN
NO: YES (1)/NO (0)
2.
The number preceding the colon (:) on
the second line indicates the current
setting. Press [1] followed by [#
Command] to enable the serial
connection.
3.
Press [0] followed by [# Command] to
disable the serial connection.
4.
Press [* Clear] to return to the
Programming Menu.