TREADMILLS – OWNER’S MANUAL
45
6.3. LUBRICANT APPLICATION
NOTE
– It is important to only use Bodyguard Fitness authorized lubricant.
IMPORTANT
: It is recommended to clean and lubricate the belt and deck surface if the treadmill has not been operated for a
period of 3 months or more.
1. Clean the deck surface and the inside part of the belt with a dry piece of fabric.
Clean the belt first, using a long piece of fabric across the belt and start the
belt so it makes two complete turns. Then, release the tension on the rear
roller to be able to clear the deck surface of any debris.
2. Open the tube of lubricant supplied by your dealer. Place the tube under and
in the middle of the belt about 15 inches from the hood cover. Step on the
treadmill and press down with your feet where the lubricant tube is located
under the belt to make sure that most of the lubricant is now spread evenly on
the deck surface. DO NOT START THE TREADMILL YET.
3. Remove the LUBE TUBE from under the belt and put the tension back again
on the rear roller. Stand where you applied the lubricant and press
JustGo
TM
to start the belt turning at 0.5 mph (or 0.8 km/h). Let the belt bring you to the
back of the treadmill and then come back where you were standing. Do this 3
times in order to spread the lubricant over the total surface of the deck. Start
the treadmill and get the speed up to 2 m/h or 3.2 km/h to make sure the belt
alignment is correct. If problems occur, please refer to the Troubleshooting
Guide below.
6.4. TREADMILL PARTS
T240S-T240P-T240C-T300-T460XC-T500
1) ON/OFF switch
2) Breaker
6.5. QUICK TROUBLESHOOTING CHECKLIST
Table 3 - Troubleshooting Checklist
PROBLEMS
POSSIBLE CAUSE / SOLUTION
•
Computer will not light up when power
is turned ON.
•
Unit is not plugged in / Plug unit in.
•
Power cord / Check that power cord is functional; replace if
necessary.
•
Circuit breaker / Reset the breaker.
•
Damaged motor drive board / Contact your Bodyguard
Dealer.
•
The wires are not connected / Remove the cover and connect the
wires properly.
•
Belt does not turn.
•
Magnetic key is not in place / Insert the magnetic key.
•
Incline does not respond properly.
•
It is not calibrated / Perform Incline Calibration.
•
The wires are not connected on the motor circuit board / Connect
the incline motor wires to the circuit board.
•
Motor drive does not respond properly.
•
The wires are not connected on the motor circuit board / Motor
wiring harness needs to be connected to the lower board.
•
Motor turns backwards.
•
The wires are reversed on the circuit drive / Contact your
Bodyguard
Dealer.
1 2
Содержание T240C
Страница 2: ......
