User Manual for BCL-X Series Laser Machine
52
VII Equipment's maintenance
7.1 Daily maintenance
Equipment's working environment could not be too severe. If temperature is higher than
30
℃，
lower than 18
℃，
and if there is too much dust, with severe air pollution, then the
machine could be badly damaged, failure rate goes up steadily. Various electric parts are
easily damaged under wet environment.
7.2 Water tank’s change and clean
We recommend to clean water tank and change the circulating water per week.
Attention: Before starting the machine, there must be full of circulating water and no
bubble in laser tube.
The quality and temperature of circulating water have a direct influence on life time of
laser tube. We recommend to use purified water and control the water temperature under
35
℃
. If the temperature is over 35
℃
, you need to change circulating water or put ice in
the water to cool door water temperature. (Recommend the customer to use water chiller
or two water tanks )
Clean water tank:
firstly, switch off electric power, take off the water-inlet water tube to let water inside
laser tube go to water tank. Open water tank, take out water pump, clean dirt on it. After
cleaning water tank, changing new recycling water, put back the water pump. Connecting
water tube on pump to water-inlet gate, and other joints. Connect electric power to water
pump separately for 2-3 minutes(make laser tube be full of recycling water).
7.3 Exhaust fan’s clean
After long term's using of exhaust fan, it would accumulate much solid dust, which could
make exhaust fan produce big noise and it is also not good for eliminating wasted air and
smell. When it occurs that exhaust fan is not good enough to suck and eliminate air,
firstly close the power, take off air-in and out tubes, remove dust inside, bottom up the
exhaust fan, roll fan blades inside until it's totally cleaned. Finally, set up the exhaust fan.
7.4 Reflector’s and lens’ clean
We suggest to clean the reflectors and lens, before starting the machine everyday, while
the equipment should be under power off situation.
There are 3 reflectors and 1 lens on Laser equipment(The first reflector is set on emission
exit of laser tube, means on the laser equipment's upper-left side. The second reflector is
