User Manual for BCL-X Series Laser Machine
23
Laser shoot from laser emitter goes through first, second and third reflection mirror successively and
reaches to work table through focus lens. Its working principle is to get the best engraving and cutting
effects after several reflections and focus. If laser path is not smooth, it may damage laser generator,
reflection mirror, focus lens etc. Please re-adjust the laser path if it is not correct.
Detailed procedures of adjusting laser path are as below:
1. Adjust first reflection mirror
The best effect is that the facula from laser tube is in right of the center.
Adjusting method:
Paste a 3mm acrylic on the first reflection mirror.
Press pulse button.
Check whether the facula shoot is on the first reflection mirror. If it is not on the first reflection
mirror, please adjust the installation position of laser tube or mirror mount.
2.Adjust second reflection mirror
The best effect is that the facula reflected by the first reflection mirror is in the right of
the second reflection mirror center.
Adjusting method:
Paste a 3mm acrylic on the second reflection mirror. The second reflection mirror is
in the far left of the crossbeam.
Press the direction button on control panel to make the crossbeam move to the
nearest place near first reflection mirror.
Then press pulse button and check the position of the shoot facula.
Press the direction button on control panel to make the crossbeam move to the
furthest place near first reflection mirror.
Then press pulse button, do not move the crossbeam and check if the facula is
identical with the facula from near place. If they are not identical, please adjust 3
screws behind the back of first reflection mirror, until they are identical. After they
are identical, move the crossbeam front and back to check if they are still identical in
the right of the mirror. If not, please fine-tune 11,12.13 screws of mirror base and
turn the second reflection mirror mount.
Attention:
Before adjusting, make sure the light outlet of laser tube
should be identical with the hole of laser head. Laser from
laser tube should be in the back of the center in the mirror
which can make the laser path reflection better. Adjusting
method: adjust the installation position of laser tube or first
reflection mirror mount.
