User Manual for BCL-X Series Laser Machine
17
Laser tube devanning:
Open the carton box, take out the laser tube. Both hands hold the middle of the tube; take
off the sponge supports; take off the packing sponge; take off the zip lock bag. Then
inspect whether the tube is intact.
Attention: It needs as least two persons when unboxing. Handle the tube with care.
3.2.2 Installation of Laser tube
Move the equipment to the back place, so as to install the laser tube easily.
The laser tube is installed in the back of crossbeam.Open the laser tube protective cover.
You can see two laser supports, two water pipes, a black color low-tension line and a red
color high-tension line.
Low-tension line
High-tension line
Laser tube installation:
1.Take off the screw from the two laser support which are used for fitting the laser tube.
2.Put the outlet(low-tension part) of the laser tube on the base facing to the first reflected
mirror.
3.Buckle the upper part of the laser tube support, tighten the screw, connect the
high-tension&low-tension line and outlet&inlet water tube.
4.Fix the laser tube.
Attention:
Keep the laser tube outlet clear in case of front mirror breakdown. The broken
damage caused by improper operation, will not be in Bodor's range of protection.
Fix the laser tube with proper strength. Larger strength will broke the laser tube.
Keep the laser tube water inlet in the lower place, and the water outlet in
the higher place(in the upper section of laser tube). Come in from the bottom, out
from the top as shown in the above picture.
Water tube joints must be connect well avoiding water leaking. Water tube must be
straightened.
Handle laser tube carefully when installing.High-tension wire and cathode rays
should be fastened enough.Water inlet should be in the bottom and water outlet in the
top. Make sure there is no air bubble in the laser tube. Use even force on the two
sides when pushing laser tube sockets to fix the laser tube. Do not use too much
force avoiding the damage of laser tube.
