BMW 320d xDrive, Руководство пользователя

Страница: 76 / 145

Refere
nce
Overview
Controls
Dr
iv
ing
hints
Mobi
li
ty
75
5. To program additional original hand-held
transmitters, repeat steps 3 and 4.
The corresponding memory button 1 is now
programmed with the same signal as the origi-
nal hand-held transmitter.
You can operate the system when the engine is
running or when the ignition is switched on.
If the system fails to function even after
repeated programming, check whether
the original hand-held transmitter uses an alter-
nating-code system. To establish this, either
consult the operating instructions for the origi-
nal hand-held transmitter or press the pro-
grammed memory button
1 on the integrated
universal remote control for a longer period. If
the LED
2
on the integrated universal remote
control flashes rapidly for a short while and then
remains lit for about two seconds, the original
hand-held transmitter uses an alternating-code
system. If it uses an alternating-code system,
program the memory buttons
1 as described
under Alternating-code hand-held transmit-
ter.
<
Alternating-code hand-held
transmitter
To program the integrated universal remote
control, consult the operating instructions for
the device to be operated. The instructions
should indicate what scope there is for synchro-
nisation.
When programming an alternating-code hand-
held transmitter, the following additional points
should be noted:
Programming will be easier if another per-
son is available to assist you.
<
1. Park your car within the range of the radio
remote control device.
2. Program the integrated universal remote
control as described above under Fixed-
code hand-held transmitter.
3. Establish the location of the button on the
receiver of the device to be operated, e.g.
on the drive system.
4. Press the button on the receiver of the
device to be operated. Once step 4 has
been performed, step 5 must be completed
within about 30 seconds.
5. Press programmed memory button 1 on
the integrated universal remote control
three times.
The corresponding memory button 1 is now
programmed with the same signal as the origi-
nal hand-held transmitter.
If you have any queries, please contact
your BMW Service centre.
<
Deleting memorised settings
Press both outer memory buttons 1 for approx.
20 seconds until the LED
2
flashes: all memo-
rised settings have been cleared.
It is not possible to clear the settings individu-
ally.
Inside mirror with digital compass*
1
Adjustment button
2 Display
The display shows you the cardinal or diagonal
direction in which you are driving.
Online Edition for Part-No. 01 41 0 159 204 - © 03/05 BMW AG