Blue Seal Evolution Series, Руководство по обслуживанию

Страница: 81 / 94

A
Appendix A: Hob Type Conversion
79
Blue Seal Evolution Series Gas Convection Ranges © Copyright Moffat Ltd. 21 June 2016
Amendment 13
Griddle - Removal
1. Turn ‘OFF’ the gas supply at the main supply.
2. Carefully lift off the griddle plate section from the top
of the cook top.
3. Remove the gas control heat shield from the griddle
burner box. This is a loose fit in the burner box.
(See Fig 6).
4. Remove all the gas control knobs from the control
panel. These are a push fit onto the gas control
valve shaft.
5. Unscrew the securing screws and carefully support
the front control panel.
6. Disconnect the lead from the piezo igniter to the rear
of the piezo igniter push button.
7. Remove the front control panel and unscrew the nut
securing the piezo igniter button to the control panel.
(See Fig 7).
8. Remove the piezo igniter button from the front
control panel.
9. Unscrew the griddle gas control valve from the gas
manifold. (See Fig 8).
10. Remove the brass blanking plug fitted to the right
hand gas manifold port (See Fig 8) and fit the
supplied spigot assembly using a suitable joining
compound which resists the breakdown action of
LPG, unless compression fittings are used. Tighten
the spigot securely.
11. Unscrew the 2 securing screws at the rear (See Fig
9) and 2 screws at the front of the griddle burner
module, (See Fig 10) and carefully remove the
griddle burner module from the burner box.
12. Remove the 3 screws securing the griddle burner
guide rails fitted to the side of the pot stand support
and to the inner side of the burner box and remove
the guide rails. (See to Fig 11).
Cook Top Open Burners Fitting - (PF Option)
Before fitting the cook top burner assembly into
the burner box area, it would be advisable to
check and fit the correct main injectors to the
cook top burners.
1. Remove the existing main injectors from the supplied
cook top open burner module and replace with the
correct size injectors for the gas being used. Refer
to the 'Supplied Parts' list at the front of this
‘Instruction Sheet’ for the correct injector sizes to
use.
2. Fit the burner module into position in the burner box
and connect the 2 gas valves (See Fig 12) to the 2
spigots on the gas manifold, using a suitable joining
compound which resists the breakdown action of
LPG, unless compression fittings are used. Tighten
up the 2 gas valves securely.
3. Secure the burner module in position in the burner
box with 2 screws at the front (See Fig 10) and rear
(See Fig 13).of the burner.
Fig 12
Gas Control
Supply Connections
Gas Manifold
Fig 10
Front Burner Securing Screws
Fig 11
Guide Rail
Guide Rail
Attachment Screws
Fig 6
Heat
Shield
Burner
Gas Control Valve
Connection
Fig 8
Gas Manifold
Blanking Plug
Rear Burner
Securing Screws
Fig 13
Fig 7
Piezo Igniter
Securing Nut
Piezo Igniter
Button
Rear Burner Securing
Screws
Fig 9