Blodgett DFG-100 Series, Инструкция по установке и эксплуатации

Страница: 13 / 205

Installation
10
Utility Connection
ELECTRICAL CONNECTION
NOTE: Electrical connection must be performed
by a qualified installer only.
NOTE: The electrical connection must comply
with National and Local codes.
A strain relief for the supply cord is required. The
installer must provide a supply cord bushing that
meets all Local and National Installation Stan-
dards.
For Gas Models:
NOTE: Gas models have a phase sensitive burner
control unit. If the phase and neutral are
switched the control locks out.
Connect phase + n ground.
For Electric Models:
Connect the oven to a separate group with rigid
connection and circuit breaker. The circuit breaker
should disconnect all poles, including neutral with
a contact separation of at least 3 mm.
For 1 Phase --- Connect phase + n
ground.
For 3 Phase --- Connect L1 + L2 + L3 + n
ground.
INITIAL STARTUP
1. Set the THERMOSTAT to 260
_
C and operate
for 2 hours prior to loading product. This pro-
cedure produces smoke.
2. Clean the oven after the initial burn-in process.
See page 20 for proper cleaning instructions.
KW/S i V l Ph
Frequency
(H )
Max Load
KW/Section Voltage Phase
q y
(Hz)
L1 L2 L3 N
CTB/CTBR
5,6 400 3N 50 9 8 8 1
8,0 400 3N 50 13 11 11 2
KCO-25E
3,0 230 1N 50 13 --- --- 13
Mark V-III
11,0 400 3N 50 18 15 15 3
Zephaire-E
11,0 400 3N 50 18 15 15 3
DFG-100-3
0,7 230 1N 50 3 --- --- 3
DFG-50
0,7 230 1N 50 3 --- --- 3
Zephaire-G-L
0,7 230 1N 50 3 --- --- 3
AC-500
1,3 230 1N 50 6 --- --- 6