Blink Wall Mount Charging System, Руководство по установке

Страница: 17 / 29

IM0001_L2_R_WMv1.3
13
WARNING: All four lag screws (and anchors, if applicable) must be installed to prevent the
charger assembly from pulling out of the wall.
CAUTION: Do not over-tighten the lag screws when mounting the charger housing assembly on the
wall. Over-tightening can deform and damage the housing base plate.
Cord reel installation
To install the cord reel:
1. Choose an appropriate place on the wall for mounting the cord reel assembly. This can be below
or to either side of the charger assembly.
2. Locate and mark the centers of two studs in the mounting area, if applicable. (Omit this step if the
charger assembly is being mounted on a brick or concrete wall and wall anchors are used.)
3. Place the cord reel cleat (Item 11, Figure 4) in the desired location on the wall with the mounting
holes in the cleat over the marked studs, if applicable.
4. Using the cleat as a template, mark the centers of the four mounting holes and remove the cleat
from the wall.
5. Using a 3/16-inch drill bit, drill a pilot hole for each of the mounting holes (wood-framed wall).
For brick or concrete walls, metal anchors must be placed in the wall. Follow the manufacturer’s
installation instructions for wall anchors that provide a minimum pull-out force of 80 lbs (36 kg);
install four anchors.
6. Place the cleat back in position on the wall and install four ¼-nch lag screws with washers (Items
5 and 6, Figure 4) to secure the cleat in place. Tighten the screws enough to remove any gaps
between the wall, cleat, washer, and screw head.
CAUTION: Do not over-tighten the lag screws when mounting the Cord Reel Cleat on the wall.
Over-tightening can deform and damage the cleat.
Figure 6 – Cord Reel Installation