Blink Wall Mount Charging System, Руководство по установке

Страница: 20 / 29

16
IM0001_L2_R_WMv1.3
Connecting power to the blink
Input power
IMPORTANT: Electrical power to the blink must be installed by a certified electrical contractor
who is familiar with local codes and standards that apply to the installation of structural components
and electrical equipment. Minimum size and color-coding requirements must be in accordance with
any applicable state or local code, and the National Electrical Code.
Voltage/Phase 208-240 VAC/1 phase (120 VAC to GND)
Rated Current
30 Amps (maximum); 12A, 16A and 24A available (WE-30C/K)
48 Amps (maximum); 12A, 16A, 24A and 30A available (WE-48C/K)
Circuit Rating
40 Amps; settings at 15A, 20A and 30A available
CAUTION: The blink EVSE’s factory default current setting is 30 amps. If the device is connected to
a lower current setting, a qualified blink technician must adjust the device settings and reset the unit
before use.
Connecting the blink
WARNING: RISK OF ELECTRIC SHOCK
Verify that electrical power to the blink input power wiring is disconnected. Electric shock
can kill!
NOTE
: The following procedure covers the installation of a blink that is being hard-wired to the
main service panel. This procedure does not apply to the optional cord-connected wall-mount blinks .
Cord-connected blinks require the installation of a NEMA 6-50R receptacle in close proximity to the
charger housing assembly. For these installations, insert the power cord into the 6-50R receptacle and
then test the
blink using ECOtality’s Car-in-a-Box equipment. Refer to the blink
Car-in-a-Box
Operator’s Manual
(OM0002_CIB) for more information.