Operating Manual
49
12) In the wheel dressing, please let the diamond pen do the movement in
constant speed. If the roughness of the wheel require more low, the speed
will be more slow. The total quantity of the wheel dressing is 0.1mm in single
section, and repeat several times. The rough dressing is about 0.01-0.13mm
every time, and the accurate dressing is less than 0.01mm. Please start the
dressing from the wheel center, because the two edges consumption of the
wheel is more. If the dressing is starting from the two edges, it will cause the
diamond pen break.
13) In the wheel dressing the operators need to add the coolant which can
make the dressing fast and more efficiency. The suitable coolant can remove
much heat from the dresser, and increase the diamond pen working life.
Please make the coolant clean so that the coolant can be used for many
times. Before the off daily work, please turn off the coolant and let the wheel
run few circles so that to avoid the wheel break.
14) In the wheel dressing, please reduce the shake to avoid to make the
scratches on the workpiece surface. That is very important. It is necessary to
make the wheel balance very well. At the same time, please avoid the shake
from the machine so that to make sure the most min. pendency and the
dresser fixed on the base tightly, then the dresser gets the enough stiffness.
If the diamond pen is not fastened very tightly, which will cause the shake
and noisy, then the workpiece will get the some scratches or waves and also
the dresser will get the damages.
5.7. BALANCING
WHEEL
The grinding wheel must be dressed before balancing.
The balancing method is according to the operation of the bubble balancing
Содержание WSG1640AHD
