Operating Manual
35
feed” mode again, push the button SB6 , the program will going on
again.
While the auto down feed program is going, push soft KEY F8, the
program will be cancel, and the grind head will lift up auto.
3) Other operating
Under the default menu, press “ ESC” two times, the system will go into
“operator menu” and “diagnostic menu)
In the “diagnostic menu”, there are many important data, the operator
must not modify these data, for if the data be modified, the contact
between the PLC to HMI will be interrupt
Factory parameter of TD400 is list as follow
TD400
add.
:
1
PLC
add.
2
Parameter
add.
200
Baud rate
187K( the real value is 187.5K)
HAS
31
GUF
10
Contrast
ratio
40
In case of the data be modified by mistake, the engineer can reset the
data according to about parameter
NOTE: while HMI show Servo alarm, make HMI power off and then restart.
6. Wheel head spindle motor start
Turn the SA5 to “ magnetized” position
, push F6 (HMI), start the oil
pump, then depress the F5, the spindle motor start (the HL2 alarm lamp will
light); depress F1, the spindle motor stop.
Содержание WSG1640AHD
