Bioness VEC-1000, Руководство для клиницистов

Страница: 25 / 111

16
Clinician's Guide
Manual Controls
Warning: The Vector Elite system is not intended for patient transport. Using the system as a
transport could cause serious patient injury.
When the Training Session Screen opens, only the Manual Controls are enabled. See Figure 5-3. The
Manual Controls allow the user to winch the rope up and down, and move the trolley along the track.
See Table 5-1.
The Manual Control buttons are used to position the trolley on the track, lower the Support Rope to
connect the patient harness to the spreader bar, and winch up the Support Rope to the desired tension.
Manual Control Button Definition
Winches the Support Rope and Spreader Bar up and down until
the button is released.
Moves the trolley along the track in the direction indicated until
the button is released. Reference the trolley icon to determine
the direction of the movement.
Moves the trolley 18 inches (45.7 cm) along the track in the
direction indicated and stops. Reference the trolley icon to
determine the direction of the movement.
Table 5-1: Manual Control Button Definitions
To manually winch down, there must be a minimum tension of 0.5 lbs. (0.23 kgs.) applied to the rope.
This is achieved by allowing the spreader bar to hang freely. This minimum tension prevents damage to
trolley hardware pieces including the winch drum, finger guard, and rope. If at any time a manual winch-
down is initiated or in process, and the minimum tension cannot be detected by the system, a warning
message window will be displayed. See Figure 5-5.
Once the minimum tension has been applied the amount of unloading will be displayed in green. Press
the X button to close out of the warning message window and continue to winch down.