Binder 9020-0423, Руководство по эксплуатации

Страница: 28 / 85

KB ECO / KB ECO-UL (E6.2) 12/2021 Page 28/85
Safety controller
The safety controller settings remain in effect. Please note that with the set-point type offset, the automatic
switchover can trigger a safety controller alarm. Recommended setting: Setpoint type “Limit” above the
higher of the two set-points.
The tolerance band alarm is always effective.
Setting
Path: Normal display Setpoint switchover
„Setpoint switchover“ menu
Setpoint switchover
With the
OK button you can change to activate/deactivate and configure the Control by date.
With the OK button + arrow-down button you can change to activate/deactivate and configure the der
Cyclic control.
In state of delivery, both control modes are deactivated.
A soon as one of the control is activated, setpoint switchover becomes enabled.
8.1 Control by date
In this menu you can enter date and time at which the alternative setpoint should be activated and deac-
tivated once.
Path:
Normal display Setpoint switchover Date controlled
“Date controlled” menu
Date controlled
Press the OK button to enable the setting.
“Active” submenu
The current setting flashes. Select with the
arrow buttons
between
YES (date controlled switchover active) and NO (no date controlled
switchover).
To activate date controlled switchover, select “YES” and press the
OK
button to confirm.
Active
With the arrow-down button you can change to enter the date to activate the alternative setpoint . Press
the
OK button
to enable the setting.