Beretta SC ACS 160 E, Руководство пользователя

Страница: 14 / 32

14
PRELIMINARY CHECKS
First of all, carefully remove the outer packing, then:
- Remove the cardboard from around the unit.
- Remove the protective nylon sheet.
- Disassemble and remove the protective wooden cage using a lever to remove the
staples.
- Separate the mixer from the pallet by loosening the feet (1) and sliding off the bracket
(2) securing the mixer to the pallet.
Check that the unit is complete and undamaged. If any defect or damage is detected,
do not install or attempt to repair the product but return it to the retailer.
Dispose of packaging in compliance with applicable law.
b
Make sure that the installation position provides easy visibility of and access to
the safety valves.
b
Connect the safety valves to a drain in conformity to applicable standards.
b
Install the product as near as practical to the storage cylinder. The product is de-
signed to work with a pipe length of 4 metres (inlet and return) between itself and the storage cylinder.
b
Disconnect the product from the mains power supply before commencing any work on it.
b
The product must be installed in conformity to the laws and standards applicable in the country of installation.
b
The manufacturer’s responsibility ends with the supply of the product. The product must be installed in accordance
with industry standards by suitably qualified persons working for a company that will assume full responsibility for
the completed installation.
INSTALLATION AND PUTTING INTO SERVICE
Bear in mind the following before installing the product:
- The product is designed to mix domestic hot water from a storage cylinder. Any other use, or any use incompatible with
the product’s technical specifications, is considered improper. Do not connect the product directly to a boiler.
- The product is not designed to be operated by children or persons with limited physical, psychological, sensorial or
mental capacities.
- If the piping needed to connect the product to the water system is damaged, it must be replaced by a suitably qualified
person.
- The installation must comply with all applicable laws and standards.
b
Installation and connection of the product must be performed by an authorised, specialist company. The company
installing the product assumes all responsibility for ensuring that the installation and functioning of the product
conform to applicable standards.
b
The product must be stored in a dry place where it is not subject to frost. The product must be installed where it is
protected against splashes of water. Ambient temperature in the place of installation must not exceed 40°C during
functioning of the product.
b
It is advisable to install the product as near as practically possible to the storage cylinder, in order to avoid unne-
cessary heat loss from the connecting pipes. The product must be placed on a surface that is flat and stable, as far
as possible, and levelled up by means of the adjustable feet provided.
b
Adjust the feet to level the unit and eliminate all stresses.
SAFETY WARNINGS
- The unit can become hot enough to cause burns if touched.
- In the event of a power failure, the motorised control valve could remain in the open position, causing the whole system
to become hot enough to cause burns if touched.
- Water in the unit can be very hot and under pressure. Therefore, before performing any work, always drain the unit and
close the shut-off valves on the primary and secondary circuits.
- The unit must be installed and put into service in strict conformity to all laws and standards applicable in the place of
2
1