Bentel KYO 32 M, Руководство по установке

Страница: 63 / 88

63
Section 3 - Programming from PC
Type
This section will allow you to select the operating mode of the 8 telephone
Numbers.
To program the Type:
1 . select the Telephone Number;
2 . program the following parameters for the selected Telephone Number.
z z z z z
Telemonitoring
- This option will allow the Control panel to communicate
with the Central Station. It will be necessary to program parameters in the
Telemonitoring section.
z z z z z
Voice Message
- This option will allow the Control panel to send a Voice
Message (this option requires the NC2/VOX).
z z
z z
z
Teleservice - This option will allow the Control panel to manage
Teleservice calls.
z z z z z
None - No service.
Partitions
This section will allow you to assign the selected Telephone Number to the
Partitions. It is possible to change a Telephone Number by entering a Main User
Code at a Keypad (the Code and Keypad must be assigned to the Partition of the
Telephone number concerned).
The ‘Teleservice’ option will activate the Reporting Protocol list (below).
z z z z z
Protocol - The Reporting protocol is usually assigned by the Central Sta-
tion. This system supports the following formats:
ADEMCO / SILENT KNIGHT - Slow 10 baud - 3/1, 4/1, 4/2
ADEMCO / SILENT KNIGHT - Fast 14 baud - 3/1, 4/1, 4/2
FRANKLIN / SECOA / DCI-VERTEX - Fast 20 baud - 3/1, 4/1, 4/2
RADIONICS - 40 baud - 3/1, 4/1, 4/2
SCANTRONIC - 10 baud - 3/1, 4/1, 4/2
CONTACT ID
CESA
z z z z z
Customer Code - This code is usually assigned by the Central Station, and
allows their operator to identify the system (user, location, type of system,
etc.).
The Customer Codes must have 4 digits
(5 for CESA protocol): 0 through
9 and A to F (hexadecimal).
For Contact ID — ‘
0
’ and ‘
A
’ have the same value.
For Pulse protocols — ‘
0
’ corresponds to 10 pulses, whereas ‘
A
’ corre-
sponds to ‘0’ pulses (empty digit).
When using Pulse protocols with 3 digit codes, the fourth digit must be pro-
grammed as ‘A’.