Bentel KYO 32 M, Руководство по установке

Страница: 41 / 88

41
Section 3 - Programming from PC
Tam.
- GREEN Zone in Standby; AMBER Tamper on Zone;
AMBER BLINKING Tamper in Memory
Byp. - GREEN Zone Unbypassed; AMBER Zone Bypassed
To Bypass/Unbypass a Zone - Using the left button on the mouse, select
the Zone then click the right button and select the required option from
the Pop-up menu. This
command can be sent
ONLY
when the Zone is
Enabled on a Disarmed Partition.
Partitions - This section provides the following information for each of
the Control panel Partitions:
No.
- Identifier Number
Description
- Partition Label
Al. - GREEN All the zones of the Partition are in Standby
RED At least one of the zones of the Partition is in Alarm
Status
- This column indicates the Arming mode of the Partition (refer
to table 3.1).
To Arm/Disarm a Partition: using the left button on the mouse, select
the Partition then click the right button and select the required option
from the Pop-up menu.
Tamper
- This section indicates current Tamper conditions:
GREEN No Tamper; RED Tamper present
Trouble - This section indicates current Trouble conditions:
GREEN No Trouble; RED Trouble present
Outputs - This section indicates the current status of the OC Outputs:
GREEN Output in Standby; RED Output Active
To turn ON/OFF an Output:
using the left button on the mouse, select the
Output then click the right button and select the required option from the
Pop-up menu. This applies ONLY to Outputs which have been set up for
“Remote Command” (refer to the ‘Output Page’).
Tamper in memory
and
Siren
- This section indicates the current
status of the ‘Tamper Memory’ and ‘Siren’:
Tamper in memory RED Tamper events in Memory
Siren RED The Alarm Output (or Output relay) is Active
Reset Alarm Memory
or
Reset Alarms -
You can reset the Alarm
memory or stop ongoing Alarms by means of the button. For further
information, refer to the relevant paragraph in the USER MANUAL.
Press the Close button ( )to exit the
System enquiry and control
session.