signal via Telephone the start and/or end of their asso-
ciated Events.
Each Dialler Action can send a Voice Message to a
maximum of 32 Telephone numbers.
Message Queue
The Dialler will not end the call until
all the messages destined for the connected telephone
number have been sent. This feature reduces call time
and costs.
+
Events will not be queued when the
Call success-
ful number
option is
Enabled
(refer to “Options”
under “Dialler”).
The layout of the
Dialler
page is as follows.
+
The Dialler parameters apply to all the numbers in
the
Dialler book
.
n
Dialler book
The
Dialler book
will allow you to assign up to 32 Tele-
phone numbers from the
General book
(refer to “Tele-
phone”) to the Dialler Facility.
No.
This is the Identifier number (1 through 32) which
represents the Telephone number in the
Actions
win-
dow.
This Identifier number DOES NOT CORRESPOND to
the Telephone Number ID number in the General
Phonebook.
Telephone Number
This field will allow you to select
the Telephone Number the Dialler must call.
1.
Click on the field you wish to program.
2.
Click again on the same field: the program will dis-
play the Telephone Numbers in the General
Phonebook.
3.
Select the required Telephone Number.
+
The ID numbers can be entered in any order. How-
ever, the sequence defined in the Dialler
phonebook will determine the call priority.
n
Send Message after ...
This section will allow you to program when the Voice
Message announcement.
Voice on line
If this option is enabled, the Voice mes-
sage will be played after detection of a voice response.
If the Control Panel does not detect a voice response
within the programmed
Voice timeout
, it will hang-up
and generate a
Dialler action failed
event.
Dial
If this option is enabled, the Voice message will be
played after Dialling.
Time out
If this option is enabled, the Voice message
will be played when the programmed
Delay
after dial-
ling expires.
+
All calls that comply with the programmed
Send
Message After
conditions will be considered Suc-
cessful. However, only the
Voice on Line
option
ensures a proper response to calls, therefore, if
you select
Dial
or
Timeout
, you should also enable
Confirm successful calls
option.
Voice Timeout
This field will allow you to program a
pause after dialling. If the Control Panel does not detect
a voice answer within the programmed
Voice timeout
,
it will hang-up and generate a
Dialler action failed
event.
+
The
Voice Timeout
applies to the
Voice on Line
option (under
Send Message After ...
).
Valid entries: 1 through 255 seconds, in 1-second steps
Default setting: 15 seconds
Delay
This field will allow you to program a pause be-
tween the end of dialling and the Voice Message an-
nouncement.
KYO 300-KYO100
PROGRAMMING
51
Figure 36
Dialler page