Bennett SITE MASTER EMV, Сборка

Страница: 12 / 28

Bennett Site Master Instruction Manual Installation
8
SITE MASTER SP FOOTP RINT
Refer to Footprint Diagram (125927 – P4208) located inside the Site Master or on the USB provided. Note: Information below is subject
to change without notice and some options shown are not available on all models.
DIMENSION NOTES:
1. Dimensions are in Inches
2. Inside opening in lower enclosure = 8-13/16” x 10-13/16"
INSTALLATION NOTES:
A. Installation must be in accordance with national electric code (NFPA 70), The Automotive and Marine Service Code (NFPA 30A), and
all state and local codes
B. Use only Underwriters Listed Threaded Rigid Conduit and Listed Sealing Fittings with conductor Seals.
C. Field connections are done in the upper electrical enclosure. Wire must extend 60 inches above base of the Site Master to make
electrical connections.
D. Shims should only be used under bolts to ensure the Site Master is level. Improper shimming that result in misaligned frames is NOT
covered under the Bennett Limited Warranty.
Figure 0.4 –Footprint