Bender ATICS-2-63A-DIO, Руководство пользователя

Страница: 76 / 104

Menu mode: Operation and setting
76 ATICS-DIO_D00080_01_M_XXEN/04.2015
Selecting a data logger:
1. Use the "

" arrow button to go to the data logger setting. Press "
↵
".
2. Use the arrow buttons to select one data logger (1, 2, …) or all data loggers (ATICS-2-DIO: 1…4,
ATICS-4-DIO: 1…11). Press "
↵
" to confirm your selection.
Adjusting settings and deleting data loggers:
10. I(3) Load current downstream of the transfer switching device on phase L3
11. I(N) Load current downstream of the transfer switching device on neutral con-
ductor N
Risk of premature wear of the memory chip
The service life of the 300 memory locations of the EEPROM memory is limited to
about 100 000 memory accesses. If one change to a measured value is saved
every second, the end of the service life of the EEPROM is reached after one year.
If one change to the measured value is saved every minute, then the service life is
increased by about 57 years. Select the settings in the "Datalogger -> "Modific."
settings menu in a way that frequent saving over longer periods of time can be
avoided.
To protect the memory module, a minimum limit threshold of 10 A for the load
current is incorporated in the data logger for the TN system and a minimum limit
threshold of 20 % in the data logger for the IT system. Values below this limit
threshold are only stored once. A new measured value will be stored in the mem-
ory chip only when this limit threshold is exceeded.
Menu Meaning
Exit Exit settings menu "Datalogger"; go up one menu level
1. Modific.: Once the measured value is changed according to the set % value, a new meas-
ured value is saved to the data logger.
Setting range:
0 … 100 %
Resolution of setting: 1 %
Data logger Meaning
No.:4 U2(1-N)
Exit
1.Modific.: 10.00 %
2.Overwrite: yes
No.:1..11
Exit
1.Modific.: 10.00 %
2.Overwrite: yes
Set one
data logger
Set all data loggers