Bender ATICS-2-63A-DIO, Руководство пользователя

Страница: 71 / 104

Menu mode: Operation and setting
71 ATICS-DIO_D00080_01_M_XXEN/04.2015
7.3.4.4 Settings menu 4: Relay
On this menu, you can adjust settings for the mode of operation and function of the relay outputs
(alarm relays). For each relay the function can be set: alarm message, operational status message,
generator start. This setting affects the action of the following menus.
If "Alarm" is set and then "Line 1:on" is selected, the relay switches when Line 1 has failed. If "Enable"
is set and then "Line 1:on" is selected, the relay switches when Line 1 is in operation. The setting "on"
can be selected for several menus simultaneously. The relay switches when at least one of the con-
ditions is met.
If "GenSt" is set for alarm relay 1, the operating mode will always be set to "N/C-T" on. The other set-
tings on the "Relay 1" menu are disabled. The alarm message "Failure Line 2" is suppressed.
Select a relay as follows:
1. Use the arrow button "

" to set the alarm relay. Press "
↵
".
2. Use the arrow buttons to select an alarm relay (e.g. Relay 2) or all the four alarm relays
(Relay 1…4). Press "
↵
" to confirm your selection.
Adjusting the settings:
If the setting "L-Gen" is selected on the "Changeover -> System" settings menu,
the alarm relay is permanently set to:
- 1. Mode:
GenSt
- 2. Relay mode: N/C-T
- Menu items 4 … 9
disabled
Menu
Meaning
Exit Exit settings menu "Relays"; go up one menu level
1. Mode ALARM Relay switches if at least one of the following menus 3…6 is set
to "on" and the associated alarm message appears.
Enable Relay switches if at least one of the following menus 3…6 is set
to "on" and the associated alarm message does
not appear
(operational status message)
GenSt Relay is used as a generator start relay (alarm relay 1 only)
Relay: 2
Exit
1.Mode: Alarm
2.Relay mode:N/C-T
Relay: 1..4
Exit
1.Mode: Alarm
2.Relay mode:N/C-T
Setting one relay
Setting all the four relays