Bender ATICS-2-63A-DIO, Руководство пользователя

Страница: 43 / 104

Commissioning, settings and testing
43 ATICS-DIO_D00080_01_M_XXEN/04.2015

If several transfer switching devices are connected in series in a power supply system, it is rec-
ommended that they be time-graded.
Setting: Response delay t(on), return transfer delay time t(2->1) and delay on release t(off).

As part of the response delay (to be custom-set), you must, at the very least, take into account
the periods of time when the circuit experiences short interruptions, and the response times of
the short-circuit protection equipment upstream or downstream. Regardless of this, a switcho-
ver pause corresponding to the installation location should be taken into account, in order to
avoid switching overvoltages.
Setting: Response delay t(on), dead time t(0) and return transfer delay time t(2->1).
The factory settings and system-specific settings of the ATICS-DIO transfer switching device are doc-
umented on the checklist. Please carry out all the work outlined in the list and log each test step.
Keep the checklist with this manual in the vicinity of the device.
5.3 Addressing examples
An automatic transfer switching device with two MK…
* These alarm addresses are used for MKs… to monitor each other for device failure.
Insert terminating resistors correctly
Communication via the BMS bus is only guaranteed when there is a terminating
resistor at the beginning and the end of the BMS bus. Other terminating resistors
cause malfunction and must not be used. Please also note the information in the
"BMS bus" instruction leaflet.
Device Parameters Address settings for one transfer switching device
ATICS®
Bus address 3
MK…
Address 1
Alarm address 3, 2*
MK…
Address 2
Alarm address 3, 1*