Belden HIRSCHMANN BRS20, Руководство пользователя

Страница: 44 / 88

44
Installation BRS20/22/30/32/40/42/50/52
Release 06 03/2020
For the supply voltage to be connected, perform the following steps:

Remove the terminal connector from the device.

Connect the wires according to the pin assignment on the device with
the clamps.

Fasten the wires in the terminal block by tightening the terminal
screws.

Mount the terminal block on the device using screws.
2.4.2 Signal contact (optional)
Figure 14: (1) Connection on the device, (2) terminal block mounted on the device
(front view), tightening torque, (3) terminal block mounted on the device
(view from above).
Proceed as follows:

Connect the signal contact lines with the terminal block connections.

Fasten the wires in the terminal block by tightening the terminal screws.

Mount the terminal block on the device using screws.
Without using PoE or
PoE+:
DC voltage Rated voltage range DC:
24 V DC ... 48 V DC + Plus terminal of the supply
voltage
Voltage range DC incl.
maximum tolerances:
19 V DC ... 60 V DC - Minus terminal of the supply
voltage
Type of the voltages
that can be
connected Specification of the supply
voltage Pin assignment
Table 10: Supply voltage with characteristic value P: type and specification of the
supply voltage, pin assignment
4.4 lb-in
0.5 Nm
RELAY
1
2
3