Belden GRASS VALLEY KMV-3901, Инструкция по установке и обслуживанию

Страница: 92 / 128

92
System Configuration
Correlating Monitor Wall Destinations and KX Router Logical Routers for the RCP-200
with the room name you selected in step 2 .
• If the room you selected belongs to a cluster system, rotate the HEAD knob (or touch
the DISPLAY SELECT category) to display a head view from a different member of the
cluster, and then touch a monitor.
The ROUTER SELECT category becomes selected instead of ASSIGN CHANNEL, and the
right-hand screen shows the message prompting you to select a router from the left-
hand screen, prefixed with the name of the multiviewer, which means that you still
need to complete the correlation between some monitor wall destinations and the
representation of the KX Router logical router for this multiviewer. See
Correlating
Monitor Wall Destinations and KX Router Logical Routers for the RCP-200 on page 92.
Repeat this for one head, with one layout, for every multiviewer that is part of the
cluster of cascade. If you need to connect to a different instance of the same room then
you will have to establish the correlation again, to be able to operate the monitor wall
from the different context.
For more information on the RCP-200, refer to the RCP-200 Guide to Installation and
Operation . See Related Documentation , on page 9.
Correlating Monitor Wall Destinations and KX Router Logical Routers for the
RCP-200
To operate the monitor wall from the RCP-200’s category/index router view, your system
must have been configured to be controlled as a router. In a layout, the RCP-200 can only
control monitors that have been assigned a monitor wall destination. The first time you log
on to a room from the RCP-200, you will be prompted to select a router from the left-hand
screen. By selecting the appropriate KX Router logical router, you will establish the
correlation between your multiviewer’s monitor wall destinations and the RCP-200’s
representation of the multiviewer’s
KX Router logical router. In the case of a cluster or
cascade system, you will also be prompted to select a router, the first time to try to assign a
source to a monitor located in a part of the layout that belongs to a different member of the
cluster or cascade. You only need to do this once, for every multiviewer that is part of a
cluster (or cascade).
To correlate a monitor wall destination in a layout and the corresponding KX Router
logical router
1 In the list on the left-hand screen, touch the KX Router logical router associated with the
multiviewer whose name was indicated in the message prompting to select a router
(you can see the multiviewer name, its IP address, and the size of that particular KX
Router).
Notes
• The RCP-200 will remember your user credentials until you log out
explicitly (by touching LOG OUT at the upper-right corner of the control
panel).
• The pointer may flicker when two RCP users access displays fed by the
same multiviewer output.
• Two users accessing the same display will be limited to sharing a single
pointer.