Belden GRASS VALLEY KMV-3901, Инструкция по установке и обслуживанию

Страница: 32 / 128

32
Frame Control Panel Operation and IP Network Setup
Changing the Multiviewer’s IP Address from the Densité Control Panel
7 Repeat step 3 to step 5 to configure the netmask.
8 Once you have set the network mask and navigated back to the previous menu level,
press the [–] button again.
DEFAULT GW EDIT appears on the control panel’s display.
9 Repeat step 3 to step 5 to configure the gateway.
10 Once you have set the gateway, press the Select button on the front edge of the
KMV-3901/3911 card to exit the control menu.
The card restarts. The startup sequence takes approximately five minutes, during which
time the Status LED is blinking orange. Once the startup has completed, the Status LED
should be red (steady) because the card is not connected to the network yet.
11 Connect the KMV-3901/3911 card to your Ethernet switch (see Cabling Diagram , on
page 21).
12 Check the card’s Status LED again, and make sure that it does not indicate an error
condition. See Status LED , on page 15.
If the Status LED indicates an error condition, see Card Interfaces , on page 15 to find
out what the other LEDs might be indicating.
13 Verify that the new IP address is effective. See Verifying the Multiviewer’s IP Address
and Application Version , on page 100.
At this point, it is recommended to back up the new configuration to the controller’s
non-volatile memory by saving a
restore point .
14 On the Densité frame’s local control panel, press the CONTROLLER button. See Using
the Densité Frame Control Panel , on page 27.
15 Press the [–] button repeatedly until RESTORE POINTS appears on the display, and then
press the SEL button.
16 Press the [–] button repeatedly until SAVE A CARD appears on the display, and then
press the SEL button.
17 Press the [–] button repeatedly until CARD # N—where N matches the slot number for
the KMV-3901/3911 card whose configuration you wish to save—appears on the
display, and then press the SEL button.
18 If you had to change the Densité controller’s default action from update settings to keep
settings in order to configure your card’s network settings, then see Enabling the
Densité Controller’s Restore-Point Settings , on page 33 again, to revert the default
action to update settings .
Notes
• If you do not press any button on the Densité frame local control panel, the
Densité controller will revert to its normal standby mode, and the selected
card's Status LED will revert to its normal operating mode, after 30
seconds.
• If you changed a parameter from the card’s control menu, but have not
applied your change (you did not press the SEL button on the local control
panel), once the 30-second timeout has occurred, the parameters will be
confirmed as if you had pressed the SEL button.