Belden GRASS VALLEY KMV-3901, Инструкция по установке и обслуживанию

Страница: 118 / 128

118
Configuring a KMV-3901/3911 Cascade
Configuring Layouts for a Cascade Room
• In the case of a cascade with two multiviewers, select the other multiviewer (i.e. the
one farthest from the monitor wall) from the Layer 2 head (for cascade
configuration) list.
3 In the case of a dual-head cascade, repeat the procedure to configure the head
assignments for the other head.
4 On the File menu, click Save .
The updated room configuration is automatically propagated to the other multiviewers
in the cascade.
Configuring Layouts for a Cascade Room
Creating cascade layouts is no different than creating any regular layout. The only limitation
is that all layout creation and configuration must be performed in online mode, while
connected to one of the cascade members.
• When you configure layouts for a cascade room, all channels from all the multiviewers
associated with this cascade room are available.
• When you save a cascade layout, any changes are automatically propagated to the
other multiviewers in the cascade.
Repairing a Cascade Configuration
While connected in XEdit to a multiviewer that is part of a cascade, if you change the
system name or IP address of this multiviewer while another cascade member is offline or
otherwise unavailable, the underlying cluster’s integrity will be broken. If you attempt to
make such a change, XEdit will alert you of the situation, prompting you to cancel the
operation and try again later, when all cascade members are available. Changing the
system name or IP address of a KMV-3901/3911 multiviewer associated with a cascade, by
using the card’s control panel on the Densité housing frame, or by using the
KMV-3901/3911 control panel in iControl, is also not supported. To maintain the integrity of
the underlying cluster configuration, you must use XAdmin to make any such changes.