Belden GRASS VALLEY KMV-3901, Инструкция по установке и обслуживанию

Страница: 29 / 128

29
KMV-3901/KMV-3911
Installation & Service Manual
* All KMV-3901/3911 cards within a housing frame must have their output heads configured with the same
refresh rate. If your frame is referenced, then the heads’ refresh rate must also match the reference signal's
refresh rate.
** Parameters shown here in braces { } will display the actual value of the item and not the text shown above.
Saving a Restore Point to the Controller’s Non-Volatile Memory
The Densité CPU-ETH2 controller can be configured to automatically apply parameters
from a previously saved restore point, when you replace a card with another card of the
same type. The restore point includes the multiviewer’s system name and networking
parameters.
To save a restore point to the controller’s non-volatile memory, proceed as follows:
1 On the Densité frame’s local control panel, press the CONTROLLER button. See Using
the Densité Frame Control Panel , on page 27.
2 Press the [-] button repeatedly until RESTORE POINTS appears on the display, and then
press the SEL button.
3 Press the [-] button repeatedly until SAVE A CARD appears on the display, and then
press the SEL button.
4 Press the [-] button repeatedly until CARD # N-where N matches the slot number for the
Kaleido-Modular card whose configuration you wish to save-appears on the display,
and then press the SEL button.
HEAD2 {List of resolutions;* = current}**
{LINK STATE}**
GPIO STATUS GPI INPUTS LINE 1 {STATE}**
LINE 2 {STATE}**
LINE 3 {STATE}**
LINE 4 {STATE}**
LINE 5 {STATE}**
LINE 6 {STATE}**
LINE 7 {STATE}**
LINE 8 {STATE}**
GPI OUTPUTS LINE 1 {STATE}**
LINE 2 {STATE}**
{FAN STATUS}**
NETWORK SETTINGS IP ADDRESS EDIT ###.###.###.###
NETMASK EDIT ###.###.###.###
DEFAULT GW EDIT ###.###.###.###
{MAC ADDRESS}**
KMV-3901/3911 user interface (local menu structure) (continued)