Belden GRASS VALLEY KMV-3901, Инструкция по установке и обслуживанию

Страница: 27 / 128

27
Frame Control Panel Operation and IP
Network Setup
This chapter shows the multiviewer interfaces, explains the local operations that can be
performed, and it explains how to implement IP network connectivity with the multiviewer.
The KMV-3901/3911 can be controlled in the following ways:
• On the Densité frame, the local control panel and its buttons can be used to navigate
menus and adjust parameter values (see Using the Densité Frame Control Panel , on
page 27).
• Grass Valley’s iControl system can be used to access the card’s operating parameters
from a remote computer, using a convenient graphical user interface (see Remote
Control Using iControl , on page 75).
• The loading and management of layouts is handled via a Java-based application, XEdit,
accessed through a dedicated Ethernet port (see the Kaleido Software User’s Manual,
(available on the Grass Valley support portal).
• A GPI interface allows remote layout selection.
• The output resolution of the card can be controlled automatically through the EDID
interface with the display.
• The RCP-200 advanced remote control panel, and the Kaleido-RCP2 control panel allow
you to perform operations on the monitor wall, either by themselves or in association
with an external keyboard and a mouse. Refer to the RCP-200, Kaleido-RCP2, and
Kaleido Software documentation. See
Related Documentation , on page 9.
Using the Densité Frame Control Panel
All of the cards installed in a Densité frame are connected to the frame’s controller card,
which handles all interaction between the cards and the outside world. There are no
operating controls located on the cards themselves. The controller supports remote
operation via its Ethernet ports, and local operation using its integrated control panel.
The local control panel is fastened to the controller card, and consists of a display unit
capable of displaying two lines of text, each 16 characters in length, and five buttons.
Densité CPU-ETH2 local control panel