Belden GRASS VALLEY KMV-3901, Инструкция по установке и обслуживанию

Страница: 19 / 128

19
KMV-3901/KMV-3911
Installation & Service Manual
2 Connect a client PC, and the Kaleido-RCP2 (if available) to a dedicated 100Base-T
Ethernet switch (see Cabling Diagram , on page 21). You can also connect a mouse and
a keyboard to your Kaleido-RCP2.
The KMV-3901/3911 multiviewer has been configured to automatically detect the
resolution of any connected display. If the required information is not available, then a
fall-back resolution of 1920 × 1080 @ 60 Hz (HDTV) is used.
3 Connect at least one output of the multiviewer to a display that supports this
resolution (see Cabling Diagram , on page 21).
• Monitor wall displays: Connect the multiviewer’s MV OUT outputs to the displays.
• Broadcast monitors: If your installation involves broadcast monitors, connect
them to the appropriate SDI outputs.
1
It is also possible to connect SDI outputs to a
router. Refer to Configuring the HD-SDI Monitoring Output Format , in the Kaleido
Software User’s Manual, for instructions on setting the scan format. See Related
Documentation , on page 9.
If you wish to use a different resolution, see Changing the Mosaic Output Resolution ,
on page 100, for detailed instructions.
4 Connect one or more video sources to your multiviewer’s inputs (see Cabling Diagram ,
on page 21).
5 Check that all SDI LEDs associated with the connected video inputs are green. See SDI
LEDs , on page 17.
Notes
• The Kaleido-RCP2 is an optional device, and may not have been shipped
with your KMV-3901/3911 system. For information on this and other
options for your multiviewer system, contact your Grass Valley sales
representative.
• You may need to upgrade your Kaleido-RCP2 devices (if available) to the
latest firmware. See Software and Firmware Updates , on page 10. Refer to
the Kaleido-RCP2 Guide to Installation and Operation for instructions on
how to determine the firmware level, and how to perform the upgrade.
See Related Documentation , on page 9 .
1.Available on KMV-3901/3911 only.
Note:
If your display is not collocated with your Densité frame you may
choose to employ a DXF-200 transmitter/receiver device that allows you to
install a display up to 1,000 meters (3,300 feet) from the signal source. For
more information on the DXF-200, refer to the
DXF-200 DVI/HDMI Optical
Extension System User’s Manual . See Related Documentation , on page 9 .