Belden GRASS VALLEY KMV-3901, Инструкция по установке и обслуживанию

Страница: 31 / 128

31
KMV-3901/KMV-3911
Installation & Service Manual
Changing the Multiviewer’s IP Address from the Densité Control
Panel
To change the IP address of a KMV-3901/3911 multiviewer card
1 Press the Select button on the front edge of the KMV-3901/3911 card. See Card
Interfaces , on page 15.
The Status LED on the selected card flashes orange, and the associated control menu
appears on the display of the Densité frame’s local control panel. See
Using the Densité
Frame Control Panel , on page 27.
2 On the local control panel, press the [–] button repeatedly until NETWORK SETTINGS
appears on the display, and then press the SEL button.
IP ADDRESS EDIT appears on the control panel’s display.
3 Press the SEL button again.
The current IP address appears on the display.
• Press the [+] and [–] buttons, to change the current value at the current input
position.
• Press SEL to move one position to the right.
• Press ESC to move one position to the left.
4 When the LCD display shows the desired IP address, press SEL to apply your change.
5 Press ESC to return to the previous menu level.
IP ADDRESS EDIT appears on the control panel’s display.
6 Press the [–] button.
NETMASK EDIT appears on the control panel’s display.
IMPORTANT
Before changing a KMV-3901/3911 multiviewer’s IP address, you must first
make sure that the Densité controller’s restore-point settings will not
prevent you from doing so, and momentarily adjust the controller’s settings
if needed. See
Enabling the Densité Controller’s Restore-Point Settings , on
page 33.
Note:
You can navigate the control menu by using the four buttons located
beneath the display:
• Press the [+] and [–] buttons, to navigate between menu options or
between parameter values.
• Press SEL to access the next menu level. When a parameter value is shown
on the display, modify the value by using the [+] and [–] buttons, and then
press SEL to apply the new value.
• Press ESC to go back to the previous menu level.
• Once you have completed your changes, press the Select button
on the
front edge of the KMV-3901/3911 card to exit the control menu.
Note:
Pressing ESC when the input focus is in the first position returns to
the previous menu level.