10
EURORACK MX3242X
1.2.4 Shipping
Your EURORACK MX3242X was carefully packed in the factory and the packaging was designed to protect the
unit from rough handling. Nevertheless, we recommend that you carefully examine the packaging and its
contents for any signs of physical damage, which may have occurred in transit.
+
If the unit is damaged, please do not return it to us, but notify your dealer and the shipping
company immediately. Otherwise claims for damage or replacement may not be granted.
1.2.5 Mounting the MX3242X in a rack
In the shipping carton youll find two 19" mounting angles which can be fixed to the side panels of the console.
Remove the side panels by loosening the screws (3 per side) that fix them to the console, lay the panels aside
and use the screws to fasten the mounting angles. Please note that each angle can be mounted on a specific
side only.
To be able to reach the rear connectors when the MX3242X is mounted in a rack, you should rotate the
interface panel by 90° (after loosening the screws holding it), and refix it. The following screws must be
removed:
1) 4 screws on the upper part of the interface panel.
2) Another 4 screws on the cover plate directly mounted to the interface panel at an angle of 90°.
3) 6 screws each on the left and right side panels.
Once the interface panel has been rotated, please check that all ribbon cables are seated and connected
properly. Then tighten all screws.
+
Ensure sufficient air space around the MX3242X. Never mount the unit in close proximity to a
power amp or similar device to avoid overheating.
+
Please note that both PSU and EURORACK will heat up during operation. This is completely
normal and does not indicate a malfunction.
2. OPERATION
2.1 Main input channel
Fig. 2.1: Connecting a signal source to a Main input channel
1. INTRODUCTION
